Buffalo Shield revision for B3SE
As I said, I will release a new revision of the Buffalo shield that will have better support for the B3SE. Since that will probably take some time, in the meanwhile, this is what B3SE (or 32s or II)...
View ArticleThe Raspberry Pi: Low cost music streamer
Enter the Raspberry Pi B+: It features: A Broadcom BCM2835 SoC processor running at 700MHz 512MB of RAM A Micro SD slot for storage A 10/100Mbps Ethernet port 4 x USB2.0 ports An HDMI output port An...
View ArticleThe Raspberry Pi: Audio out through I2S
There are currently four ways to get audio out of the RPi: Use the audio out 3.5mm jack. It’s very easy to get it to work, but the sound quality is pretty bad, since it uses PWM to generate the sound....
View ArticleTFT HiFiDuino v2!
It’s official: Version 2 of the TFT HiFiDuino controller is complete! There is a number of changes, thus the new version: New minimal display mode as default. Goes into full display when changes are to...
View ArticleTFT HiFiDuino v2.01 + video
As is usually the case, a few bugs crept into the v2 release. So, here is v2.01: TFT_HiFiDuino_v2.xx (1652 downloads) (Note: As always, the code on this page may not be the current one, i.e. there may...
View ArticleUpdate: TFT HiFiDuino v2.13
I did a little work on the TFT HiFiDuino code, incorporating most of the enhancements I made to the ArDAM1021 code. These are the enhancements: Option of displaying white text & graphics on black...
View ArticleUniversal Signal Isolator Shield: Rev. 1.2
Since there has been a lot of interest in my Isolator shield these past few months, I have been optimizing its design. The result of this optimization is this PCB: It’s called “the Rev. 1.2”. Nothing...
View ArticleIdeon Audio 3R USB Renaissance
OK, so this small Greek company comes up with a USB regenerator gadget targeted towards audiophiles. They claim that it improves audio dramatically. It uncovers lost detail, enhances dynamics, etc....
View ArticleYes, I put an ES9028Pro on my Buffalo III
A few years back I was hit by Murphy and I was hit hard. It was the time when you had to be very patient and even somewhat lucky if you wanted to buy a Buffalo DAC. You had to wait for the boards to go...
View ArticleTFT HiFiDUINO Pro update..
I finally managed to find the time to actually integrate my upgraded Buffalo III board into my Buffalo DAC. In the process I discovered and took care of a number of bugs in my TFT HiFiDUINO Pro code....
View Article
More Pages to Explore .....